Horizontal heated towel rails buying guide
A horizontal heated towel rail is one heated bar that runs across the wall, usually 600mm to 830mm long, and it suits the low walls and short walls where a vertical rail will not fit. For most bathrooms the right call is a set of two or three horizontal bars stacked at an even spacing, which gives the look of a ladder and enough heated surface for several towels. This guide sets out the horizontal rails in this collection, with their sizes, power and wiring.
Vertical or horizontal
The wall decides. A vertical rail suits a narrow gap between a door and a vanity or a shower screen and a wall. A horizontal rail suits a wide, low wall, such as the space under a window or above a vanity, where height is limited. Neither dries a towel as well as a heated towel ladder, because a single bar has less surface contact than a ladder. A vertical Thermorail heats to around 35 degrees, and a towel placed over the bars insulates the rail and lifts the temperature under the towel to between 50 and 55 degrees. Use one bar per towel, and add a second or third bar if more towels hang at once. The vertical heated towel rails and single bar heated towel rails collections hold the other single bars.
The horizontal rails in this collection
| Rail | Size | Power and rating | Fixing and wiring |
|---|---|---|---|
| Thermogroup 12V round single | 632mm by 32mm, 100mm deep | 12V, 18 watts, IP45 | Mounting points 600mm apart, right-hand concealed wiring, transformer included |
| Thermogroup 12V square single | 632mm by 40mm, 100mm deep | 12V, 23 watts | Transformer included |
| Thermogroup 12V square single, long | 832mm wide | 12V, 30 watts, IP45 | Transformer included |
| Thermogroup 12V round, short | 450mm long | 12V, 14 watts, IP45 | Sold per single rail |
| Thermogroup 12V flat pill | 632mm long | 12V, 13 watts, IP45 | Transformer included |
| Nero Bianca 240V | 632mm by 40mm, 70mm deep | 240V, 15 watts, IP55 | Fixing distance 592mm, Multiflex concealed hardwired wiring, 1.5 metre lead |
| Nero Mecca 240V single | 632mm long, 90mm projection | 240V, 15 watts, IP55 | Multiflex concealed hardwired wiring, 1.5 metre lead |
| Caroma Liano II horizontal | 640mm by 32mm, 75mm deep | 12V, 12 watts, IP55 | Fixing distance 600mm, transformer sold separately |
| Caroma Urbane II horizontal | 640mm by 40mm, 65mm deep | 12V, 12 to 15 watts, IP55 | Fixing distance 600mm, right-hand wiring, transformer sold separately |
| Phoenix round and square | 600mm and 800mm | 12V, 35 watts, IPX5 | Mounts vertically or horizontally, transformer included, hardwired by a licensed electrician |
Why a set of two or three
Thermogroup single bars are sold individually and are designed to be installed in sets of three or more. A minimum of three single rails gives enough heated surface in contact with the towels to help them dry. Caroma horizontal rails are also sold individually, and Caroma recommends installing two or three rails to optimise heating. A set of three also reads as a ladder, and the rail count and spacing are yours to choose.
| Set of three | Total load | Transformer |
|---|---|---|
| Nero Bianca, 15 watts each | 45 watts | None, 240V |
| Caroma Liano II, 12 watts each | 36 watts | One 72W transformer serves one to three rails |
| Thermogroup 12V round, 18 watts each | 54 watts | Included with each rail |
| Phoenix round, 35 watts each | 105 watts | Included, with a triple rail holding three |
12V or 240V
- 12V rails run from a transformer, and they can go anywhere in the bathroom, including Zone 1. The transformer must sit outside Zone 2, within 2 metres of the rail, with adequate access and ventilation, and a 12V rail can only be hardwired. The 12 volt heated towel rails collection holds the full range.
- 240V rails connect straight to mains power with no transformer. The Nero Bianca and Mecca singles are 240V, with concealed hardwired wiring. The 240V heated towel rails collection holds the mains-powered rails.
Heat is set by wattage, not voltage. A 12V rail and a 240V rail of the same size and wattage give off the same heat.
Wiring and fixing
The Thermogroup 12V horizontal singles have right-hand concealed wiring. The Caroma Urbane II horizontal has right-hand wiring, and the Liano II horizontal wires through the left or right mounting post, both concealed and hardwired by a licensed electrician. Phoenix rails have an integrated on and off switch, with the cable leaving through the bottom mount. Choose the cable side before the wall is set out, because on a horizontal bar the cable end has to sit where the connection is.
Have a qualified electrician install and test the rail. For a Thermogroup rail, mount it on a flat wall at least 600mm above the floor, with 300mm clear of permanent fixtures. Screw into studs where possible, use anchors on a hollow wall, and protect the rail with a suitably rated RCD circuit.
Which horizontal rail suits which wall
- A short wall of about 450mm: the Thermogroup 12V round, 450mm long, in a set of three.
- A wall of 600mm to 650mm under a window: a 632mm Thermogroup, Nero or Phoenix 600mm bar, or a 640mm Caroma bar.
- A wide, low wall above a vanity: the 832mm Thermogroup square single or a Phoenix 800mm rail.
- A wall that also needs a vertical bar: a Phoenix rail, which mounts either way.
How hot a horizontal rail gets
A heated towel rail is not a radiator. The Caroma rails run at 40 degrees, give or take 5, in a 22 degree room, and a Thermorail single bar heats to around 35 degrees before a towel is placed on it. That is enough to dry a towel and keep it warm. It does not heat the room, so a bathroom that needs warm air also needs a ceiling heater or underfloor heating, which the bathroom heating and ventilation collection covers.
Hidden warmth when the wall is full
When there is no wall left for a visible rail, the Thermogroup Thermorad in-wall panel dries towels without one. It sits in the wall cavity behind a towel rail, robe hook or ladder, and it works with any of them. The large panel is 405mm wide and 1150mm high overall, with a heated area of 350mm by 930mm, and it is 25mm thick. It has a maximum temperature of 50 degrees, draws 160 watts, has a 2 metre lead and runs on a programmable timer.
Planning a stacked set
Plan the set on the wall before the wiring is run. Each bar needs its own connection, so the cable position, the lead length and the spacing all have to be set before the wall is lined. Keep the bars the same length and fix them from the same line so the set reads as one piece. Decide where the transformer will sit for a 12V set, and whether one transformer can serve the set: the Caroma 72W transformer serves up to three rails, and the Thermogroup and Phoenix 12V rails include their own.
Sizing the rail to the wall
Measure the wall before the rail. Overall size is the footprint on the wall, and the fixing distance is the distance between the mounts. They are different numbers: the Caroma Liano II horizontal is 640mm long with a 600mm fixing distance, and the Nero Bianca is 632mm long with a 592mm fixing distance. Set out the holes from the fixing distance, and leave clear wall above and below the rail so air moves around the towels. A set of three bars needs the height of all three bars plus the gaps between them.
What a horizontal rail uses
Divide the rail's wattage by 1,000, then multiply by the hours it runs. A 12 watt bar running six hours a day uses 0.07 kilowatt-hours. A 15 watt Nero bar uses 0.09, and a 35 watt Phoenix rail uses 0.21. A set of three 15 watt bars uses 0.27 over the same six hours. A rail should not run constantly, because heat builds up under the towel, and a timer keeps the running hours to the ones that count. The controllers and thermostats and Thermogroup timers and thermostats collections hold timers that match the rail.
Timers and switching
The Thermogroup Eco Timer sits behind the switch plate and runs a 12-hour schedule, so the rail is on at the same time every morning and evening, for 1 to 11 hours at 50, 75 or 100 per cent heat. The TRTS touchscreen timers set two heating periods a day across seven days and have a manual override. Phoenix rails have an integrated on and off switch on the rail, so they need no wall timer unless you want one. Decide how the rail will be switched before the wiring is planned, because a timer or switch needs its own position on the wall.
Finishes
Choose the finish to match the tapware in the room. The horizontal rails come in chrome, brushed nickel, black, gunmetal, brass and gold and white, as well as stainless steel and bronze.
Brands
- Thermogroup single bar heated towel rails in round, square and flat pill profiles.
- Caroma heated towel rails in the Liano II and Urbane II ranges.
- Nero heated towel rails in the Bianca and Mecca ranges.
- Phoenix heated towel rails in round and square profiles.
Care
Clean the rail with a soft cloth and a non-abrasive cleaner, because harsh scrubbing and acid cleaners mark the surface. A rail is hot to the touch, so supervise young children near it.
Where to go next
The heated towel rails collection compares every style, finish and voltage together.


