240V heated towel rails buying guide
A 240V heated towel rail connects straight to mains power, with no transformer. For most bathrooms the right call is a 240V rail wherever it can sit outside Zone 1, because it is simpler to fit and many can be plugged in as well as hardwired. A 12V rail is the choice where the rail must sit close to water. This guide sets out which 240V rails plug in and which are hardwired only, where they can go and which rails are in this collection.
Can a 240V heated towel rail be plugged in?
Some can, and some cannot. Most 240V Thermorail rails can be hardwired or plugged into a power point, and a rail that is hardwired needs an electrician. A rail that plugs in needs a power point within reach of the lead. Check the model before you order.
| Rail | Plug-in or hardwired |
|---|---|
| Thermogroup Thermorail ladders with Multiflex wiring, such as the 3 Bar, 4 Bar and 7 Bar | Hardwired or plugged in |
| Thermogroup Thin 240V vertical | Hardwired only, with a top wiring position |
| Phoenix Cromford, Radii, Five Flat Bar and Wiltern ladders | Hardwired or plugged in, cable through the bottom right vertical tube |
| Caroma Liano II ladder | Concealed hardwired or exposed plug-in, wiring at any of the four fixing posts |
| Fienza Isabella vertical | Concealed hardwired or exposed plug-in |
| Fienza Kaya ladders | Concealed hardwired only |
| Nero Mecca ladder and singles, Bianca single | Concealed hardwired wiring, with a 1.5 metre power cord |
| Meir vertical | 2.5 metre lead, no transformer |
For a Thermogroup rail, have a qualified electrician install and test it. Mount it on a flat wall at least 600mm above the floor, with 300mm clear of permanent fixtures. Screw into studs where possible, use anchors on a hollow wall, and protect the rail with a suitably rated RCD circuit.
Where a 240V rail can go
The only technical difference between a 240V and a 12V rail is the voltage that reaches it. A 240V rail is wired straight to mains power, so its position is limited by its IP rating. Most Thermorail 240V rails are IP55 and must be at least 600mm from a water source or spout. The Thermogroup 7 Bar and the other Thermorail ladders are safe in Zone 2 and the outside zones. Use a 240V rail outside Zone 1 where you can, and a 12V rail if the rail must sit in Zone 1. The 12 volt heated towel rails collection holds the 12V range. Always confirm the position with your electrician.
Heat is set by wattage, not voltage. A 240V rail and a 12V rail of the same size and wattage give off the same heat.
The 240V ladders
| Ladder | Size | Power and rating |
|---|---|---|
| Thermogroup 3 Bar | 550mm by 450mm | 33 watts, IP55 |
| Thermogroup 4 Bar | 550mm by 550mm | 41 watts, IP55 |
| Phoenix Wiltern and Five Flat Bar | 550mm to 575mm by 740mm to 750mm | 35 watts, IPX4 |
| Phoenix Cromford and Radii | 550mm to 750mm wide | 62 watts, IPX5 |
| Fienza Kaya 4 bar | 600mm by 450mm | 47.5 watts, IP55 |
| Thermogroup 7 Bar | 600mm by 800mm | 80 watts, IP55 |
| Nero Mecca 7 bar | 600mm by 800mm, 122mm deep | 80 watts, IP55 |
| Caroma Liano II 8 bar | 632mm by 900mm, 116mm deep | 68 watts, IP55 |
| Thermogroup 8 Bar | 750mm by 700mm | 104 watts, IP55 |
| Fienza Kaya 9 bar | 600mm by 1200mm | 110 watts, IP55 |
| Thermogroup 14 Bar | 1000mm by 1500mm | 244 watts, IP55 |
A ladder gives a towel more contact with the heated bars than a single bar does, so it dries and warms a towel better. More bars means more hanging space, but output does not rise in step with the bar count, so compare the output on each product.
The 240V single bars
Single bars are one heated bar, so use one bar per towel, and fit two or three side by side if more towels hang at once. The 240V singles here include the Thermogroup 240V vertical (142mm by 900mm, 20 watts, IP65), the Thermogroup Thin 240V vertical (45mm by 900mm, hardwired only), the Fienza Isabella vertical (100mm by 900mm, 27 watts), the Meir vertical (1000mm, 23 watts, IPX4) and the Nero Mecca and Bianca singles (632mm, 15 watts, IP55). The single bar heated towel rails collection holds every single bar.
The liquid-filled Mayer
The Turner Hastings Mayer is a 240V liquid-filled ladder with a 300 watt replaceable immersion element, filled with a mixture of water and glycol. It heats to approximately 55 degrees and takes 15 to 30 minutes to heat up. It has no switch on the rail, so it needs a control panel timer or a switch in the bathroom. The liquid filled heated towel rails collection holds it.
Wiring by brand
- Thermogroup ladders have Multiflex wiring, with a connection on the left and the right, and as dry electric rails they mount either way up, so the wiring can come from any of the four mounting points.
- Phoenix ladders send the cable through the bottom right vertical tube, with a lead of 1.3 or 1.4 metres. The Radii 750mm comes with both a square and a round backplate.
- Nero Mecca ladders can be surface mounted or recessed, and the power cable can connect from the left or the right, at the top or bottom mounting position. The fixing distance is 568mm across and 600mm down.
- Caroma Liano II ladders can be hardwired with concealed wiring or plugged in with exposed wiring, with a 1.4 metre lead.
- Fienza Kaya ladders have concealed wiring at the top right or the bottom left mounting point, and the Isabella has wiring available at both mounting points.
Planning a plug-in rail
A plug-in rail needs a power point in reach of the lead, so measure from the rail to the point before the wall is lined. The leads here run from 1.3 metres on the Phoenix Five Flat Bar to 1.5 metres on the Nero rails, 1.4 metres on the Caroma ladder and 2.5 metres on the Meir rail. A hardwired rail has concealed wiring, so no cord shows. Freestanding rails, which stand on the floor and need no wall mounting, plug in. The freestanding and swivel rails collection holds them.
How hot a 240V rail gets
A heated towel rail is not a radiator. A Thermogroup ladder is designed to heat up quickly and reach around 45 to 55 degrees, and a vertical Thermorail heats to around 35 degrees before a towel is placed on it. The Meir rail has a maximum surface temperature of 40 to 45 degrees, the Fienza ladders run between 35 and 60 degrees and the Caroma ladder runs at 40 degrees, give or take 5, in a 22 degree room. That is enough to dry a towel and keep it warm. It does not heat the room, so a bathroom that needs warm air also needs a ceiling heater or underfloor heating, which the bathroom heating and ventilation collection covers.
Which 240V rail suits which wall
- A small space or one towel: the Thermogroup 3 Bar or 4 Bar, or the Fienza Kaya 4 bar.
- A standard bathroom wall: a 7 bar ladder at 600mm by 800mm from Thermogroup or Nero, or the Caroma Liano II at 632mm by 900mm.
- A wide, low wall: the Thermogroup 8 Bar at 750mm by 700mm.
- A tall wall in a shared bathroom: the Fienza Kaya 9 bar at 600mm by 1200mm, or the Thermogroup 14 Bar at 1000mm by 1500mm.
- A narrow wall: a 240V vertical single bar.
What a 240V rail uses
Divide the rail's wattage by 1,000, then multiply by the hours it runs. A 15 watt single bar running six hours a day uses 0.09 kilowatt-hours. An 80 watt ladder uses 0.48, and a 110 watt Kaya uses 0.66. Left on for 24 hours the 80 watt ladder uses 1.92 kilowatt-hours, four times as much. A rail should not run constantly, because heat builds up under the towel. A timer keeps the running hours to the ones that count.
Controlling a 240V rail
Every rail needs at least an isolating switch, so it can be turned off in the room if there is a problem. The Thermogroup Eco Timer sits behind the switch plate and runs a 12-hour schedule, for 1 to 11 hours at 50, 75 or 100 per cent heat. The TRTS touchscreen timers let you program each day on its own, set all seven days the same, or set one schedule for weekdays and another for the weekend, with a manual override for drying clothes. The controllers and thermostats and Thermogroup timers and thermostats collections hold the full range.
Choosing the size and finish
Measure the wall before the rail. Overall size is the footprint on the wall, and the fixing distance is the distance between the mounts. They are different numbers, so set out the holes from the fixing distance. The size collections group rails by width and height: narrow, 500mm to 599mm, 800mm to 899mm and over 1000mm. The finish collections group them by colour: chrome, brushed nickel, black, gunmetal, brass and gold and white.
Care
Clean the rail with a soft cloth and a non-abrasive cleaner, because harsh scrubbing and acid cleaners mark the surface. Do not hang anything on the rail that has been in contact with oil, petroleum products or dry cleaning fluids. A rail is hot to the touch, so supervise young children near it.
Where to go next
The heated towel rails collection compares every brand, size, finish and voltage together.


