Over 1000mm heated towel rails buying guide
The heated towel rails in this collection are 1000mm or taller, up to 1500mm, and they suit a full-height wall, a tall narrow gap or a shared bathroom where several people need a warm towel. For most bathrooms the right call is a tall ladder if the wall is clear, or a 1000mm vertical bar if the wall is narrow. A tall rail needs a tall wall, so measure the height first. This guide sets out the tall rails with their real sizes, power and wiring.
The tall rails in this collection
| Rail | Size | Power and rating | Wiring |
|---|---|---|---|
| Meir vertical rail | 25mm by 1000mm, 70mm deep | 220 to 240V, 23 watts, IPX4 | No transformer, 2.5 metre lead |
| Caroma Urbane II vertical | 40mm by 1000mm, 60mm deep | 12V, 16.5 watts, IP55 | Transformer sold separately, concealed hardwired |
| Fienza Kaya 9 bar ladder | 600mm by 1200mm, 100mm deep | 230V, 110 watts, IP55 | Concealed hardwired |
| Thermogroup 14 Bar ladder | 1000mm by 1500mm, 122mm deep | 240V, 244 watts, IP55 | Multiflex, hardwired or plug-in |
A ladder gives a towel more contact with the heated bars than a single bar does, so it dries and warms a towel better. The Thermogroup 14 Bar is a wide, tall ladder made for a family bathroom. A single bar has less surface contact, so use one bar per towel, and fit two or three side by side if more towels hang at once. The vertical heated towel rails and single bar heated towel rails collections hold the other single bars.
How much wall height a tall rail needs
Mount a Thermogroup rail at least 600mm above the floor, with 300mm clear of permanent fixtures. Add the rail height to the 600mm to find the wall height from the floor to the top of the rail:
| Rail height | Wall height needed |
|---|---|
| 1000mm | 1,600mm |
| 1200mm | 1,800mm |
| 1500mm | 2,100mm |
A 1500mm ladder on a standard 2,400mm wall leaves 300mm above it. Check for a window, a shelf or a mirror in the path of the rail before you order.
The Meir 1000mm vertical rail
The Meir rail is 304 grade stainless steel. It needs no additional transformer, and the maximum surface temperature is 40 to 45 degrees Celsius. A hook accessory comes with the rail for hanging multiple towels on either side, and a full size template and installation instructions are included. It comes in brushed nickel, matte black, champagne, shadow, Tiger Bronze and Lustre Bronze. The champagne heated towel rails and black heated towel rails collections hold the matching finishes.
The Caroma Urbane II 1000mm vertical rail
The Urbane II vertical is 40mm wide and 1000mm high with a fixing distance of 900mm. It is a 12V rail, so it needs a transformer, which is sold separately. The matching 12V 72W transformer serves one to three rails. The wiring is concealed and hardwired through the top or bottom mounting post by a licensed electrician. The rail runs at 40 degrees, give or take 5, in a 22 degree room. It comes in polished stainless steel, matte black, gunmetal, brushed nickel, brushed bronze and brushed brass. The Caroma heated towel rails collection holds the whole range.
The Fienza Kaya 9 bar ladder
The Kaya 9 bar ladder is 600mm wide and 1200mm high, with a surface temperature between 35 and 60 degrees. It draws 110 watts at 230V and is IP55. The wiring is concealed and hardwired, so it needs an electrician. It comes in brushed nickel, chrome, matte black, gun metal and Urban Brass. The Fienza Kaya heated towel rails collection holds the 4, 6 and 9 bar versions.
The Thermogroup 14 Bar ladder
The Thermogroup 14 Bar ladder is 1000mm wide, 1500mm high and 122mm deep, and draws 244 watts at 240V. It has Multiflex wiring, with a connection on the left and the right, so the lead can leave from either side, and as a dry electric rail it can mount either way up. It can be hardwired or plugged in, and it is safe for use in Zone 2 and the outside zones. It is IP55, and 304 grade stainless steel with a polished finish.
12V or 240V
- 12V rails run from a transformer. A 12V rail can go anywhere in the bathroom, including Zone 1, as long as the transformer and any timer or switch are placed correctly for their IP rating. The transformer must sit outside Zone 2, within 2 metres of the rail, with adequate access and ventilation, and a 12V rail can only be hardwired. The 12 volt heated towel rails collection holds the full range.
- 240V rails connect straight to mains power with no transformer, and most can be hardwired or plugged in. The 240V heated towel rails collection holds them.
Heat is set by wattage, not voltage. A 12V rail and a 240V rail of the same size and wattage give off the same heat.
Installing a tall rail
Have a qualified electrician install and test the rail. Mount it on a flat wall, screw into studs where possible, and use anchors on a hollow wall. A tall rail carries more weight and a longer span, so confirm the fixing points with the installer before the wall is lined. Protect the rail with a suitably rated RCD circuit, and fit any timer or switch in the zone that suits its IP rating. A rail is hot to the touch, so supervise young children near it.
How hot a tall rail gets
A heated towel rail is not a radiator. The Meir rail has a maximum surface temperature of 40 to 45 degrees, the Fienza Kaya runs between 35 and 60 degrees, and the Caroma rails run at 40 degrees, give or take 5, in a 22 degree room. A Thermogroup ladder is designed to heat up quickly and reach around 45 to 55 degrees. That is enough to dry a towel and keep it warm. It does not heat the room, so a bathroom that needs warm air also needs a ceiling heater or underfloor heating, which the bathroom heating and ventilation collection covers.
Finishes by brand
| Rail | Finishes |
|---|---|
| Meir vertical | Brushed nickel, matte black, champagne, shadow, Tiger Bronze, Lustre Bronze |
| Caroma Urbane II vertical | Polished stainless steel, matte black, gunmetal, brushed nickel, brushed bronze, brushed brass |
| Fienza Kaya 9 bar | Brushed nickel, chrome, matte black, gun metal, Urban Brass |
| Thermogroup 14 Bar | Polished stainless steel |
Choose the finish to match the tapware in the room. The brushed nickel, chrome, gunmetal, brass and gold and stainless steel finish collections each narrow the choice.
Switching and timers
A tall rail needs a wall switch or a timer, so decide where it will sit before the wiring is planned, because a timer or switch needs its own position on the wall. The Thermogroup Eco Timer runs a 12-hour schedule, so the rail is on at the same time every morning and evening, for 1 to 11 hours at 50, 75 or 100 per cent heat. The TRTS touchscreen timers let you program each day on its own, set all seven days the same, or set one schedule for weekdays and another for the weekend, with a manual override for drying clothes.
Sizing and fixing
Measure the wall before the rail. Overall size is the footprint on the wall, and the fixing distance is the distance between the mounts. They are different numbers: the Caroma Urbane II vertical is 1000mm high with a fixing distance of 900mm. Set out the holes from the fixing distance, and leave clear wall above and below the rail so air moves around the towels. Check the lead length against the distance to the connection point: the Meir rail has a 2.5 metre lead.
What a tall rail uses
Divide the rail's wattage by 1,000, then multiply by the hours it runs. A 23 watt Meir bar running six hours a day uses 0.14 kilowatt-hours. A 110 watt Kaya ladder uses 0.66, and the 244 watt Thermogroup 14 Bar uses 1.46. Left on for 24 hours the 14 Bar uses 5.86 kilowatt-hours, four times as much. A rail should not run constantly, because heat builds up under the towel. A timer keeps the running hours to the ones that count. The Thermogroup Eco Timer sits behind the switch plate and runs a 12-hour schedule, and the controllers and thermostats and Thermogroup timers and thermostats collections hold the full range.
Which tall rail suits which wall
- A narrow wall beside a door or vanity: the Meir or Caroma Urbane II vertical bar, 1000mm high.
- A tall wall in a shared bathroom: the Fienza Kaya 9 bar at 600mm by 1200mm.
- A wide, full-height wall in a large bathroom: the Thermogroup 14 Bar at 1000mm by 1500mm.
Other sizes
If the wall is shorter, the 900mm to 999mm heated towel rails and 800mm to 899mm heated towel rails collections hold shorter rails, and the heated towel rails collection compares every size, finish and voltage together.
Care
Clean the rail with a soft cloth and a non-abrasive cleaner, because harsh scrubbing and acid cleaners mark the surface. Do not hang anything on the rail that has been in contact with oil, petroleum products or dry cleaning fluids.

